Spektrum DX7 Radio Help

by Mike
(North Carolina)

I have a spektrum DX7 transmitter and AR7000 receiver.

My receiver was working fine, but now it blinks once and then does nothing when you turn it on.

I sent it back to the manufacturer, and in the mean time put an AR6000 receiver in. It worked for about ten minutes and is now doing the same thing.

I have trouble shot this over and over and cant figure it out. I use a servo reverser on the tail, for the elevator.

Could this be killing my receivers?

It is my first ARF, after foam trainer.

I am at a loss.

Comments for
Spektrum DX7 Radio Help

Click here to add your own comments

no lite on reciver ar7000
by: Anonymous

I am having the same problem... brand new radio and reciver.. battery just off the charger..reciver lights where on solid but no servo movemet.. thought it may need to bind.. followed manual instructions for binding.. now light blinks once then stays off when power is turned on for the recivers.. can not try binding again as the lights must be on to bind. spektrum DX7 transmitter and AR7000 receiver.

check battery
by: Anonymous

Hi i am sure that your battery is. low check your battery. it happen to me in my dx7, the same thing. spektum is really good, the only problem is that you need good batteries in your tx and in your rx.

Hmm
by: Matt

Hi Mike,

That has to be frustrating...

You say it was working fine.. How long did it work fine before you started having problems?

You say it blinks once when you turn it on. Do you mean when you plug the receiver battery in? Or do you mean when you turn the transmitter on?

Have you tried rebinding it to the transmitter?