Comments for Mounting the receiver Average Rating Click here to add your own comments

Rating 2.4GHz doesn't need foam by: rcdude07 If you're running 2.4GHz RXes, you don't need to wrap them in foam. We wrap 72MHz RXes to cut down on vibration interference. You should always secure the RX, whether this is with double sided tape or rubber banded down, that is up to you. The location in the plane is also up to you. It's recommended somewhere easily accessible if you need to remove servo wires or change out servos. If running 2.4GHz, be sure to lay the antenna per the instructions, typically at 90* from each other. 72MHz needs the antenna to exit the plane to get a clearer signal.

Rating Mounting the receiver by: Brad That has worked. Thanks for the information.

Rating electric reciver by: Anonymous can I use a receiver from an electric on a nitro powered? where does the battery plug in

Rating Yes it'll work by: rcdude07 Yes the RX will work in either nitro or electric. For nitro the battery plus into the battery port (batt) instead of throttle.

Click here to add your own comments Join in and write your own page! It's easy to do. How? Simply click here to return to RC Airplane Radio.